By The Swimming Pool Company
An air-source heat pump is usually cheaper to run than a gas boiler for a pool, because at the 2026 Ofgem price cap it costs less per unit of heat whenever its efficiency is above about 3. Our guidance puts a modern inverter heat pump at 5–7 in mild air, falling in cold winter air.
Key takeaways
A heat pump moves heat from the air. Our guidance puts its coefficient of performance (COP) at 5–7 at about 15°C ambient.
A gas condensing boiler has an efficiency of about 0.92. Direct electric heating has a COP of 1.
At Ofgem's October–December 2026 cap rates, a heat pump beats gas on running cost above a COP of about 3.
Below about 7°C the coil can ice up and needs a defrost cycle that briefly interrupts heating. London winter air regularly sits at 2–8°C.
For year-round use we recommend a heat pump paired with a gas boiler in a hybrid.

How does a pool heat pump work?
An air-source heat pump transfers heat from ambient air into the pool water rather than generating heat by burning something. That is why its efficiency can exceed 1. A modern inverter pool heat pump at about 15°C ambient achieves a COP of 5 to 7, which means five to seven units of heat for every unit of electricity. Direct electric heating gives one. A gas condensing boiler gives about 0.92.
COP is not a constant. It falls as the air gets colder, and the pool is hardest to heat when the air is coldest.
Which is cheaper to run: heat pump or gas?
Ofgem's price cap for 1 October to 31 December 2026 sets average rates, for a standard variable tariff paid by Direct Debit, of 26.32p per kWh for electricity and 7.97p per kWh for gas.
A gas boiler at 0.92 efficiency delivers a unit of heat for about 8.7p.
A heat pump at a COP of 4 delivers it for about 6.6p, and at a COP of 5 for about 5.3p.
The two cost the same at a COP of about 3.
So at current rates a heat pump wins when its COP is above about 3, and loses when cold air pushes it below that. This is our arithmetic from the cap rates, for illustration. Your tariff may differ, and the cap changes on 1 January 2027. We will update this article. For the maths on a whole warm-up, see our guide to swimming pool running costs.
Heat pump versus gas boiler: at a glance
Air-source heat pump | Gas boiler | Hybrid (both) | |
Efficiency | COP 5–7 at about 15°C ambient, lower in cold air | About 0.92 (condensing) | Uses whichever suits the conditions |
Upfront cost | About £2,000–£4,000 more than a gas boiler | Lower | Highest |
Cold weather | Coil can ice below about 7°C and needs a defrost cycle | Unaffected by air temperature | Gas covers cold spells |
Recovery speed | Sized for steady heating | Boilers of 100kW or more suit large pools that cool significantly and need rapid recovery | Fast recovery plus efficient running |
Other loads | Pool heating | A single condensing boiler can also serve domestic hot water and heating | Both |
Installation | Electrical, outdoor siting | Gas Safe Register engineer required, with a commissioning record | Both |
When does a heat pump make sense?
A heat pump suits most outdoor pools used mainly from spring to autumn, where air is mild and the pool is kept warm steadily rather than heated in bursts. It also suits owners who want lower running costs and are happy to pay the extra upfront. Sizing is the key. It must cover recovery after periods of non-use and the peak heat loss on cold, windy, overcast days, which is what a poorly sized unit struggles with.
Placement matters too. The unit has a fan and compressor, so its position affects how much your household and neighbours hear it. Discuss siting at design stage.

When does a gas boiler make sense?
A gas boiler rated at 100kW or more suits large pools that cool significantly and need rapid recovery, especially when used intensively and intermittently. A single high-efficiency condensing boiler can serve both the pool and the domestic hot water and heating loads, which can simplify plant in a house that already has gas. All gas pool heating work must be done by Gas Safe Register engineers, who provide a commissioning record. Our heating guidance calls this a statutory requirement.
Why a hybrid often works best
London winter air regularly sits at 2–8°C, and below about 7°C a heat pump's coil can ice up and need a defrost cycle, which briefly interrupts heating. For year-round use, we recommend a heat pump paired with a gas boiler: the heat pump does the efficient work most of the year, and the boiler covers cold snaps and fast recovery.
For indoor pools the heating question sits alongside ventilation and dehumidification, which we cover in indoor swimming pool cost. Our swimming pool heating page has more, and typical budgets are on our outdoor pool prices page.
Other ways to reduce heating costs
Cover the pool. Evaporation accounts for 50–70% of ongoing heat loss from an uncovered outdoor pool, and a cover cuts it sharply.
Integrate the controls. Linked heating, ventilation and filtration controls are said to reduce combined energy use by 30–40%.
Use a variable-speed pump. It cuts electricity use at low bather loads.

Frequently asked questions
What is the best way to heat a swimming pool in the UK?
For most outdoor pools, an air-source heat pump is the efficient default, and a heat pump with a gas boiler in a hybrid suits year-round use. A large pool needing fast recovery may justify a gas boiler of 100kW or more. The right answer depends on size, use and site.
Is a pool heat pump worth it in winter?
It works, but less efficiently. Below about 7°C the coil can ice up and needs a defrost cycle that briefly interrupts heating, and London winter air regularly sits at 2–8°C. For year-round use we recommend a hybrid with a gas boiler.
Is a heat pump cheaper than a gas boiler for a pool?
Usually to run, yes. At the October–December 2026 Ofgem cap rates, a heat pump costs less per unit of heat once its COP is above about 3. A heat pump costs about £2,000–£4,000 more upfront than a gas boiler.
How long does it take to heat a pool with a heat pump?
It depends on pool volume, unit output, air temperature and the starting water temperature, so we do not quote a single figure. Sizing must cover recovery after non-use and cold, windy days. We confirm the expected recovery time for your pool at design stage.
Do I need a Gas Safe engineer to fit a pool boiler?
Yes. All gas pool heating work must be done by Gas Safe Register engineers, who provide a commissioning record. Electrical work on the pool is done by NICEIC-registered engineers.
Sources and references
Ofgem, Changes to energy price cap between 1 October and 31 December 2026
Energy Saving Trust, Air source heat pumps: costs, savings and benefits
The Swimming Pool Company, Swimming pool heating and ventilation
Next steps
Book a free consultation, or email photographs and dimensions of your space to info@swimmingpoolcompany.co.uk for an initial assessment.

